Sinotimer Svp916 Manual Version Pdf Free Full Info
: Over-current limit reached. The total draw overpassed your P07 parameter limit. Reduce active house loads before manual or automatic resetting.
The front panel features LED indicators that display the current state of your electrical system.
: Over-voltage protection triggered. The voltage exceeded your P01 metric. It will auto-restore when voltage drops below P02 .
Recovery voltage values ( U2 / U5 ) are set too close to the cutoff thresholds ( U1 / U4 ). sinotimer svp916 manual version pdf full
Tripping mechanisms execute in under 0.1 seconds during sudden, severe surges or drops.
: Input voltage has exceeded the A1 setting. The device cuts power to output. It restores power when voltage drops to the A2 value.
Sinotimer SVP916 User Manual: Full PDF Guide & Setup Instructions The Sinotimer SVP916 : Over-current limit reached
If no button is pressed for 10 seconds, the device saves changes and exits to the main screen automatically. Troubleshooting and Fault Codes
displays a flashing light or shows an error code, follow these steps:
The safest source is directly from the manufacturer or their authorized distributors. The front panel features LED indicators that display
should be installed by a qualified electrician, following local electrical codes. Install the device on a standard 35mm DIN rail.
Use the up/down arrows to navigate through the functions.
| Mode Code | Full Name (per manual) | What it does | | :--- | :--- | :--- | | | Signal ON Delay | After power/signal, delay T1 seconds, then output ON. | | S-dN | Signal OFF Delay | Output ON instantly. Remove signal, wait T1 , output OFF. | | CYC | Cyclic (Loop) | Output ON for T1 , OFF for T2 , repeats forever. | | C-UP | Power ON delay | Power on → Wait T1 → Output ON (latches until reset). |
The device is configured using the , Up (▲) , and Down (▼) physical interface keys:
Dual LED digital display showing real-time voltage (top) and current (bottom). m.media-amazon.com Programming & Setting Instructions To adjust the device settings, follow these steps: Enter Setting Mode: Press and hold the button for 3 seconds. Navigate Parameters: