Life Probo Pr70 Instructions For Installation Use And Maintenance Manual 10 Pages Upd -
Keep in original box if unused >30 days. Avoid temperatures above 50°C.
None known when used as directed.
: Unscrew the four screws holding the omega-shaped support brackets to the base.
All wiring must be performed by a qualified technician or professional fitter. Observe the following mandatory requirements: Keep in original box if unused >30 days
[ Terminal Block Layout ] +-----+-----+-----+-----+-----+-----+-----+-----+ | 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | +-----+-----+-----+-----+-----+-----+-----+-----+ | | | | | | | | +--Antenna +--Flashing | +-Photocells +-Start Button Light +--24V Aux Output Terminal Descriptions
Remove the omega-shaped support brackets, mount the operator onto the runner (guide rail), and refasten using the provided hexagonal-headed screws.
: Built-in encoder, electronic limit switch management, structural steel runner track, and obstacle-detection logic Step 1: Pre-Installation Inspections : Unscrew the four screws holding the omega-shaped
Inspect the chain or belt tension for excessive slack.
: Switch off the power, hold down specific keys (often the start or 10 keys), and switch the power back on. Calibration
The Probo PR70 features a 24V control unit accessible by removing the main plastic cover. Always ensure the main power is turned off before touching the terminals. away from direct sunlight and moisture.
Connect USB to PC → PR70 appears as drive → copy CSV files.
| Specification | Value | | :--- | :--- | | | PR70-07 / PR70-DL | | Mains Power Supply | 230 Vac 50 Hz | | Motor Power Supply | 24 V dc | | Max. Power | 260 W | | Max. Input | 8.5 A | | Input Power to Line (230V) | 1.2 N | | Thrust | 650 N | | Lubrication | Grease | | Electromechanical End Stops | No | | Encoder | Yes (Built-in) | | Speed | 0.10 – 0.18 m/s | | Work Cycles | 50 % | | Nominal Work Time | 13 min | | Courtesy Light | 24 Vdc (internal) | | Operating Temperature | -20°C to +70°C | | Protection Class | IP20 | | Motor Insulation Class | F | | Assembly | Horizontal ceiling-mounted on dedicated runner | | Dimensions (HxWxD) | 442 x 213 x 142 mm | | Weight | 6.7 Kg | | Max. Leaf Surface Area | 11.5 m² | | Control Unit | RG1 24P / RG1 24 DL |
Auto-off after 2 minutes. Or press and hold STOP.
Before using the Life Pro Bo PR70, it is essential to follow the installation instructions carefully. The device should be placed on a flat surface, away from direct sunlight and moisture. The following steps should be taken:
2026-05-22 Document Version: 2.0 (10 Pages) Manual Code: MN-10675-ML