Fnirsi-1014d Firmware Update Jun 2026

Delete any existing files on the oscilloscope's drive and copy the new file onto it.

The FNIRSI-1014D has established itself as a staple in the "budget oscilloscope" market, favored by hobbyists for its dual-channel capabilities and integrated signal generator. However, as is common with affordable electronics, its hardware is only as capable as the firmware governing it. The story of the FNIRSI-1014D’s firmware updates is one of essential maintenance, manufacturer-side hardware shifts, and a remarkably active open-source community that has pushed the device beyond its original design. The Utility of Firmware Updates

The official flashing tools and USB drivers run natively on Windows 10 or 11.

For those looking to solve bugs or enhance their device, independent online resources have proven invaluable. The most significant source is the , where enthusiasts have been actively reverse-engineering the scope. This work has led to the creation of several open-source firmware projects. fnirsi-1014d firmware update

The original reverse‑engineering project (on EEVblog) resolved early touch‑panel coordinate problems and produced tools to reconfigure the GOODIX GT915 controller. The community has also:

The FNIRSI-1014D is picky about SD cards. It usually requires format with a Master Boot Record (MBR) .

: Loading the "wrong" official version will not brick your device; it only causes a display offset that is reversible by reflashing. Delete any existing files on the oscilloscope's drive

Key developments from the community:

Improving the speed of screen updates and improving usability in USB export mode. Prerequisites: What You Need

: It is highly recommended to delete any existing files on this newly recognized drive before proceeding. The story of the FNIRSI-1014D’s firmware updates is

Download the .bin or .hex firmware file along with the or Allwinner flashing tool (depending on what the package specifies for their chip architecture).

: Power the oscilloscope off and then back on. You should see a progress bar on the screen as it installs the new firmware.