Lovato 31 Rgam 12 User Manual — =link=

: Parameters can be programmed directly via the front keypad or through a PC using the RGAM remote control software Interface and Indicators LED Display

When a fault occurs, the display flashes an alarm code. Use the SELECT/RESET key to view or clear them: : Low oil pressure (immediate engine stop). : Engine overheating (immediate engine stop). : Failure to start after the preset number of attempts.

Yes, but only for overcurrent protection. Pass the live wire through all three phases in series (L1 and L2 paralleled, L3 unused). Phase loss sensitivity will be disabled. Consult the manual for wiring. lovato 31 rgam 12 user manual

Supports single or three-phase systems spanning 70VAC to 624VAC line-to-line.

The Lovato 31 RGAM 12 acts as the brain of a generator system. Its primary role is to monitor the mains electricity (single or three-phase) and, in the event of a failure, start the generator and transfer the load. Key Features of the 31 RGAM 12: : Parameters can be programmed directly via the

Configuration can be performed via the front keypad or specialized software.

The manual dedicates at least 10 pages to the programming sequence, accessed via the front panel’s four buttons (Menu, Up, Down, Enter). : Failure to start after the preset number of attempts

Connect the phases of your main grid to the dedicated high-voltage sensing inputs.

The manual provides a full list of all 50 parameters, including reserved and factory-locked ones.

For comprehensive parameter auditing, use the proprietary control software via a dedicated PC connection.

Check physical fluid levels immediately. Verify sensor continuity with a multimeter. Frequency / Voltage Out of Range