Connect pin RC4 (SDA) to PCF8574 SDA. Connect pin RC3 (SCL) to PCF8574 SCL. Pull-Up Resistors: Place a pull-up resistor from the SDA line to VCC ( ), and another
Elias tapped his keyboard, sending the initialization command. The address was 0x27 , standard enough, but as the liquid crystal surged to life, the glow wasn't the usual dull yellow. It was a piercing, electric cobalt.
#include <Wire.h> #include <LiquidCrystal_I2C.h> jhd2x16i2c proteus exclusive
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
The internal hardwiring of a standard JHD2X16I2C module follows this specific mapping, which must be replicated in your Proteus schematic: PCF8574 Pin Register Select P1 Read/Write (Often grounded on hardware, but connected here) P2 Enable Pin P3 LED / Backlight Controls the LCD backlight transistor P4 Data Bit 4 (4-bit mode communication) P5 Data Bit 5 P6 Data Bit 6 P7 Data Bit 7 Microcontroller to PCF8574 (I2C Bus) Connections Connect pin RC4 (SDA) to PCF8574 SDA
LiquidCrystal_I2C lcd(0x7C, 16, 2);
To accurately replicate the JHD2X16I2C behavior, the parallel pins of the LCD must be mapped precisely to the output pins of the PCF8574 expander. PCF8574 to LCD (LM016L) Wiring Matrix The address was 0x27 , standard enough, but
To simulate this module in Proteus, you must ensure the component and its corresponding software library are installed.
You might ask, "Why not just use the standard LM016L and manually attach a PCF8574 chip?"
void loop() // Blink cursor as a heartbeat lcd.setCursor(15, 1); lcd.print(millis() / 1000 % 10); delay(500);