Weltouch Cy-210b Manual Page

The WELTOUCH CY-210B is a low-power, Plug-and-Play capacitive touch controller board. It converts touch inputs from a projected capacitive (PCAP) touch sensor into digital signals recognized by Windows, Linux, and Android OS.

: Tracks total machine cycles over its operational lifetime. Work Count : Monitors current production lot numbers.

: Avoid inserting metal objects like screws or coins into the controller housing, as this can cause permanent electrical failure.

: Utilizes a toroidal coil to monitor weld current every half-cycle, correcting for variations to maintain smooth, consistent output. weltouch cy-210b manual

: If the scale enters “count mode” (pcs), you’ve accidentally pressed MODE too long. Turn the unit off and on to exit counting mode.

The system provides valuable diagnostic information. Here is an expert guide to interpreting its feedback.

Detects issues such as current out-of-range, providing warnings to prevent defective parts. 4. Technical Specifications Model: Weltouch CY-210B (Miyachi/Amada) Type: Secondary Constant Current AC Welding Control Schedules: 15 Programmable Schedules Work Count : Monitors current production lot numbers

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.

Open the back compartment. Insert (do not use carbon-zinc). Observe polarity (+/-). If the display shows “Lo” immediately, your batteries are weak or reversed.

Using a toroidal coil, the system reconstructs the current waveform to an RMS effective value, correcting the output through phase conversion and trigger pulse oscillation. : If the scale enters “count mode” (pcs),

: “My CY-210B fluctuates by 0.02g randomly.”

Need full manual? Search "weltouch cy-210b manual extended guide"

The controller must be properly grounded to prevent electric shock.

The user interface allows engineers to customize the heat profile of each weld sequence.

The device is designed for high production efficiency by including built-in monitors for: