Kincaid Radio Controlled Clock Instruction Manual Updated Review

Once the pin is removed, open the battery compartment. Kincaid clocks are powered by one fresh . Always use a new, high-quality battery, as a weak battery is a very common cause of reception problems. Ensure it's inserted according to the + and - polarity marks shown inside the compartment.

If you need to view a visual guide, searching for " How To Setup an Analog Atomic Wall Clock " can provide demonstrations of these steps.

If you change it later, press and hold the SYNC button for 5 seconds to reset the clock. kincaid radio controlled clock instruction manual

Upon inserting the batteries, the clock will initiate its startup sequence:

Press and hold the WAVE or RCC button for 3 seconds. The signal icon will start flashing immediately. Once the pin is removed, open the battery compartment

Symptom 3: The Clock Analogue Hands Shift or Spin Erratically

Your Kincaid clock contains a built-in, highly sensitive miniature antenna. Ensure it's inserted according to the + and

Ensure the DST setting in your clock's configuration menu is set to ON or AUTO . The clock will automatically read the DST bit embedded in the WWVB radio signal and advance one hour forward in the spring, or fall back one hour in the autumn.

The clock has successfully received the signal, but your Time Zone setting is incorrect. Refer to Section 3 to adjust the zone indicator (PST, MST, CST, EST).