Motomaster Battery Charger 111568 Manual -

A typical 50Ah battery will take 5-6 hours. However, if voltage is below 5V, the charger may refuse to start (see troubleshooting above).

Do not expose the charger to rain, snow, or wet environments. Control Panel and Features

Disconnect any "loads" (lights, radio) running off the battery while charging . Reverse Polarity Swap the red and black clamps to the correct terminals . 📖 Important Safety Warnings

The detected battery voltage is higher than 12V (e.g., trying to charge a 24V system). motomaster battery charger 111568 manual

The positive (POS, P, +) post is usually larger than the negative (NEG, N, -) post. Connect Positive: Attach the RED (positive) clip to the positive battery post. Connect Negative: Attach the BLACK (negative)

12V Lead-Acid, AGM, and Gel batteries.

The LCD will display the charging progress. A typical 50Ah battery will take 5-6 hours

Press the button to select between standard (Lead-Acid) or AGM/GEL.

Connect the clamp to the positive terminal of the battery (marked POS, P, or +).

The battery took too long to accept a charge, or the battery capacity is too large for the selected amperage rate. Control Panel and Features Disconnect any "loads" (lights,

The battery may have severe internal degradation preventing it from reaching full voltage.

To help you get the best use out of your charger, it would be useful to know:

Before connecting the device, ensure your electrical setup matches its hardware requirements: 120 V AC, 60 Hz

: Typically includes a basic meter to display charging current (amps) and voltage. Pros and Cons