Robopac Robot 2001 Manuale Work |top| Direct

Place a fresh roll of stretch film onto the carriage spool holder.

Select the desired pre-programmed cycle on the display panel (e.g., Up-and-Down Cycle or Up-Only Cycle).

Clean the bumper sensors and the drive wheel. 5. Safety Regulations robopac robot 2001 manuale work

This table shows some of the most common error codes that may appear on your Robopac machine.

When the Robot 2001 halts during manual or automatic work, the control panel typically triggers a specific fault state. Likely Cause Corrective Action Active E-stop or triggered bumper. Check for physical obstructions; reset E-stop buttons. Film tearing constantly Sharp pallet corners or excessive tension. Place a fresh roll of stretch film onto

Access MENU → PARAMETERS (typical values):

The Robopac Robot 2001 is a testament to robust Italian engineering. With regular, proactive care and a clear understanding of its safe operating procedures, this machine will continue to deliver reliable performance for years to come. For further technical support, manuals for newer models, or to purchase genuine spare parts, always contact an authorized Robopac distributor. Likely Cause Corrective Action Active E-stop or triggered

Internal gel or lead-acid batteries (Typically 24V DC system powered by two 12V batteries)

The tracing wheel lost contact with the pallet surface, or the floor surface is uneven/slippery.

Every Robopac machine, including the Robot 2001, is supplied with a comprehensive set of documents in a dedicated "Binder". The key components are: