Chipblaster Jv10 Manual -

| Symptom | Probable Cause | Solution | | :--- | :--- | :--- | | | Worn seals or gaskets. | Replace the main shaft seal or housing gasket. | | Unit vibrates excessively | 1. Drum is unbalanced.2. Screen is clogged. | 1. Ensure the screen is seated correctly.2. Clean the screen thoroughly.3. Check for buildup inside the drum housing. | | Poor chip "dryness" | 1. Screen is plugged.2. Feed rate is too high. | 1. Clean screen.2. Reduce the flow of chips entering the unit. | | Motor trips breaker | 1. Wrong voltage.2. Drum seized. | 1. Verify power supply.2. Check for solid metal jamming the drum. |

Ensure all electrical work is performed by a qualified electrician in compliance with local regulations. chipblaster jv10 manual

If you need specific help resolving a diagnostic error code, or if you need help with a particular section of the unit, let me know: | Symptom | Probable Cause | Solution |

Inspect the JV10 filter pressure gauges to ensure filters are clean. Drum is unbalanced

1. Clean the main machine coolant tank.2. Ensure you are using genuine 10-micron ChipBLASTER bags.

Inspect electrical enclosures for dust accumulation or loose wiring terminations. Every 2,000 Operating Hours (or Annually)