Move the plastic jumper block from (Default running position) to Pins 2-3 (Clear position). Wait 15 seconds, then move the jumper back to Pins 1-2 . Reconnect power and boot the system. Front Panel USB Headers (F_USB1 / F_USB2)
This occurs when the motherboard detects the case is open. Enter the BIOS by pressing F1 during startup, navigate to the Security tab, and set Chassis Intrusion to "Disabled". Lenovo Is6xm Rev 1.0 Motherboard Manual
The four DDR3 DIMM slots support standard non-ECC unbuffered memory. Move the plastic jumper block from (Default running
If you are moving this board into a standard ATX case, you’ll need to map your Power and Reset switches manually. Based on community findings and technical diagrams: Pin Number Typical Wire Color Power Switch (Standard) Red / Black Pin 5 & 6 Green / Black Pin 7 & 8 Yellow / Black Pin 11 & 12 Reset Switch (Optional) Blue / Black Front Panel USB Headers (F_USB1 / F_USB2) This
The IS6XM Rev 1.0 officially supports processors (32nm). Motherboard Compatibility - Linus Tech Tips
| Pin | Signal | Pin | Signal | |-----|--------|-----|--------| | 1 | HDD LED (+) | 2 | Power LED (+) | | 3 | HDD LED (-) | 4 | Power LED (-) | | 5 | Ground | 6 | Power Switch (Vcc) | | 7 | Reset Switch (+) | 8 | Power Switch (GND) | | 9 | Reset Switch (-) | 10 | Key (no pin) |
This board uses a non-standard mounting hole pattern and a proprietary front panel header. If you are moving it to a new case, you will likely need a Lenovo 14-pin to 24-pin power adapter and a custom wiring solution for the power button and LEDs. BIOS Updates: