Din 53357 Pdf -

Calculations average the tension over a specific measurement distance across 10 distinct points. 2. DIN 53357-B (German Wheel Peel Test)

is a historical German technical standard titled "Testing of plastics sheet; adhesion test" (Prüfung von Kunststoff-Folien; Trennversuch).

Quantifies peel strength or ply adhesion, typically recorded as force per unit width (e.g., Newtons per 50mm or N/cm).

When a seal swells or a gasket cracks in the field, engineers replicate the service conditions using DIN 53357 to investigate the root cause.

: Conducted without an alignment roller fixture. The specimen is gripped directly by a universal tensile testing machine.

As an official technical document, the is copyrighted and must be purchased from accredited standards retailers. You can find the PDF at: din 53357 pdf

Though no longer an active standard, the historical document is still accessible for research and legacy compliance: : Available in PDF and Hardcopy. Languages : Typically published in German and English.

or average peel force (often expressed in N/5 cm or N/15 mm). Current Status It is important to note that DIN 53357 was withdrawn

DIN 53357 outlines two primary test types, which are selected based on the specific material properties: DIN 53357 - 1982-10

was a historical German standard used to test the adhesion (peel strength) of laminates and plastic films . Although it was officially withdrawn in the late 1990s and replaced by newer European standards, it remains a common reference in technical data sheets for legacy industrial materials. 1. Purpose and Scope

It is common to confuse DIN 53357 with international equivalents. Here is a quick comparison: Calculations average the tension over a specific measurement

This procedure measures standard layer separation using basic linear tension.

Often associated with the "German wheel" or rotating wheel peel test, used to maintain a constant 90∘90 raised to the composed with power peel angle. Where to Access

: Manufacturers use this standard to verify that materials meet performance criteria for durability and functionality. 2. Testing Methodology

Testing of plastics films and plastic-coated fabrics; adhesion test. N/cm or N/15mm. Status Withdrawn (Replaced by ISO 2411/ISO 8510). Primary Use Measuring peel strength/bond quality.

Where:

: Specifically designed for plastic films, sheets, and laminated structures where layer separation (delamination) is a potential failure mode.

is a German industrial standard that describes a test method for determining the behavior of rubber and plastics when subjected to liquid media—specifically oils, fuels, and other fluids. The full title translates to: "Testing of rubber and plastics - Determination of the behavior when exposed to liquid media."

For artificial leather and similar materials, the Freiberg Institute (FILK) recommends using DIN EN ISO 2411 .

For new projects, engineers often use DIN EN ISO 2411 (for rubber- or plastics-coated fabrics) or ISO 8510-1/2 (for adhesives and peel tests) as contemporary substitutes for adhesion testing. DIN 53357 - 1982-10